TURNING THE HEATING (HEAT CURVE) UP/DOWN
Step A
To increase the temperature of the
heating, turn the offset heat curve clockwise 4 sections.
To decrease the temperature of the heating,
turn the offset heat curve anti-clockwise 4 sections.
If you have underfloor heating, please allow 24 - 36 hours for any change to take effect. With radiators the change should be noticable within a few hours.
After having carried out step A, if you are
still not fully satisfied with the temperature, please follow step B.
Step B
Check reading in menu 2.1. To do this:
Press the + button (top right), the number on the bottom left of the display
should now change from 1.0 to 2.0.
Press the enter button (←), the screen will now display menu 2.1.
Press enter
button again, the screen should now be flashing.
Press the + button to increase heat curve.
Press the – button to decrease heat curve.
Press the enter button to confirm.
If
you have adjusted the heat curve number turn the offset dial on the heat pump to 0, thereafter
using the process detailed in step A if required.
NOTE: Heat Curve Settings Guide
For radiator system - Heat Curves 10, 11 or 12
For underfloor heating - Heat Curves 8, 9 or 10
NOTES
If you are stuck in any menu, simply move the off set knob
+2 to -2 and you will always come out of the menu you are in.
All information is in the installation manual or at www.nibe.eu
under the relevant model and download documents.